Spring Replacement
Everything about spring replacement
The first step you need to do is drive your car out of the garage during Spring Replacement Santa Clarita. It is advisable not to have your car in the garage while carrying out the exercise to avoid damage. Next you need to shut the door. You cannot carry out the exercise with your door open. This could be the cause of an injury. Next you need to power off and disconnect the opener of your door. This is for the newer version of doors, for the older version of doors you need to remove the fuse or power off the circuit breaker. Make sure that you have protective wear. You should have a pair of goggles and a pair of gloves to help you in your activity. Make sure that your springs and the springs you are about to replace are of the same size. If the springs are of the same size they should not be put. It is good to remember that the activity you are carrying out is a high risk affair during Spring Replacement Santa Clarita. But, what is the torsion spring? The torsion spring is the responsible for you to be able to lift up a 150 pound garage door with barely any effort at all. It absorbs over 90 % of the weight of the door and all the torque force that involves it moving up and down is handled by the torsion spring. If you stand on your garage door on the inside of the garage you will see a metal bar on top of the door that goes from one side to another. This bar is called the torsion bar and as you may already have assumed, attached to it is the torsion spring. The spring is measuring about 1 meter long and about 10 cm wide. |